![]() ![]() Amps (Real-time charge/discharge current).Xanbus Ports Functions The Battery Monitor features six data monitoring functions including: Reset button 5 6 8 7 Figure 1-2 Conext Battery Monitor bottom panel ports 5.Ħ. It features a local display to selectively show the voltage, current, consumed amp-hours, remaining capacity and remaining hours.įeatures 1 2 4 3 Figure 1-1 Conext Battery Monitor front panel features 1. Introduction The Conext Battery Monitor is a meter for 24 V & 48 volt batteries designed for use in off-grid power systems as a wall/panel/DIN-rail mount device in stationary renewable energy applications. Failure to follow these instructions can damage equipment.Ĭontents Contents 1 Overview Introduction - Benefits of Monitoring the Battery - Features - Unpacking and Inspection -Ĭontents Mid-point Sensing - Mid-point Sensing Configurations - Trending Mid-point Voltages in Data Logs - Synchronization - Upgrading Firmware -Ĭontents Regulatory Standards - A–57 Schneider Electric Products compatible with the Battery Monitor - A–57 B Modbus Maps Overview - Supported Modbus Data Types -ġ Overview Chapter 1 describes the features of the Battery Monitor and provides an overview of its physical features and user interface. Do not use the device with Lithium Ion batteries.The Battery Monitor is intended for monitoring lead-acid batteries with a nominal voltage of up to 48 VDC.Failure to follow these instructions will result in death or serious injury. Do not lay tools or other metal parts on top of batteries.Wear protective glasses, gloves and boots.Keep sparks and flames away from the batteries. ![]() This equipment must only be installed and serviced by qualified electrical personnel.Remove watches, rings, or other metal objects.No user serviceable parts inside.ĭANGER HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH To reduce the risk of electrical fire, replace fuses with same size, type, and rating only.Install in a dry, indoor location away from direct sunlight. All wiring must be done by qualified personnel to ensure compliance with all applicable installation codes and regulations.Connect only to Safety Extra Low Voltage (SELV) circuits and power sources.Read these instructions carefully and look at the equipment to become familiar with the device before trying to install, operate, service or maintain it.ĭANGER HAZARD OF ELECTRIC SHOCK AND FIRE Read and keep this Installation Guide for future reference. Important Safety Instructions READ AND SAVE THESE INSTRUCTIONS - DO NOT DISCARD This guide contains important safety instructions for the Conext Battery Monitor that must be followed during installation and configuration procedures. CAUTION CAUTION indicates a potentially hazardous situation, which, if not avoided, can result in moderate or minor injury. WARNING WARNING indicates a potentially hazardous situation, which, if not avoided, can result in death or serious injury. DANGER DANGER indicates an imminently hazardous situation, which, if not avoided, will result in death or serious injury. Scope The Guide provides safety guidelines, planning, and setup information, procedures for installing the Battery Monitor, as well as information about configuring, monitoring, and troubleshooting the unit.Ībout This Guide Conventions Used The following conventions are used in this guide. All trademarks are owned by Schneider Electric Industries SAS or its affiliated companies.Ībout This Guide Purpose The purpose of this Owner’s Guide is to provide explanations and procedures for installing, operating, configuring, maintaining, and troubleshooting the Conext Battery Monitor. Microsoft and Excel are registered trademarks of Microsoft Corporation in the United States and/or other countries. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |